Instructions

Avanti SDO5 Instructions www.remotepro.com.au
Setting the pin-code
1. Press  button for channel 1 until you hear the long beep, the signal
light in the upper left corner flashes
2. Press button 1 twice, then press the  button to confirm
a. Long beep & the signal light stop flash means the password is
correct
b. Rapid beep means this step was done incorrectly and exit
password update (start from step 1)
3. Enter your new pin-code with 1-8 digits, press  button to confirm, the
signal light in the lower left corner flashes
a. Rapid short beep means the password exceeds 8 digits and exit
password update (start from step 1)
4. Enter the new pin-code again, then press  button to confirm
a. Long beep means the same password twice
b. Rapid short beep means different password twice and exit
password update (start from step 1)
Programming the keypad to your motor
This will program the same way your remote programs. It is best to refer to
your motor manual for the specific programming procedure. The only
difference will be when the procedure asks you to press a button on your new
remote you will be entering your pin-code and pressing the  button.
Generally (for most models), you will press the learn button once and
immediately release. Then enter your pin-code and press the  button twice.