Specifications

J326XP-IM-5AB
4-9
Troubleshooting
JCF-Z Rotor Identification
4
2 Hold the left top edge in place and insert the Allen wrench through the hole.
a. Turn to the right (clockwise) about one-half turn, until you reach a stop.
• The latch engages.
3 Repeat step 2 on the right side
• The second latch engages.
Figure 4.4 Front Panel Retaining Strip
JCF-Z Rotor Identification
The rotor identification system can, under two specific conditions, misidentify the JCF-Z
continuous flow/zonal rotor. Misidentification has occurred if a rotor name other than JCF-Z
appears in the
ROTOR display during the run, when rotor identification is complete. If the rotor is
misidentified, stop the run and follow one of the steps below.
NOTE
Misidentification can be prevented by returning your JCF-Z rotor to the Beckman Coulter factory to
have magnets added to the rotor body. The magnets ensure correct identification. Call your local
Beckman Coulter Field Service representative
*
for more information.
JCF-Z rotors manufactured after March, 1997, have factory-installed magnets.
1. Retaining Strip
1
* In the United States, call 1-800-742-2345. Outside the U.S., contact your local Beckman Coulter office.