Specifications

STOVE INSTALLATION (CONT.) - For qualified installers only! PAGE 9

7 Pull gently on the power cord to take out any extra slack. Attach the strain relief (it is shipped

attached to the power cord - see the illustration below).

Strain

Relief

Compress the

strain relief from

the top and

bottom and

insert it into the

hole until it locks

in place.

TO INSTALL THE

STRAIN RELIEF

Power Cord

8 Attach the control cover by sliding it over the attachment hooks. Place the black grill in place.

The control cover hangs on two sets of hooks on both sides. Align

the control cover and slide the bracket onto the hooks and then

move downwards.

Bracket on

Control Cover

Hooks on Side of Heater

Control Cover

talling the Gas Inlet

• Locate the 17-1/4" gas inlet

pipe included with the heater

(the shorter one may be

discarded). Apply thread

sealant to one end and insert it

through the rear panel and into

the 90° elbow on the gas

control valve. Tighten with a

pipe wrench.

! Leak check all gas line

connections.

Rear Panel

Gas Inlet

(3/8" diameter pipe)

17-1/4"

NOTE:

Apply thread sealant

prior to installing.