Specifications

STOVE INSTALLATION (CONT.) - For qualified installers only! PAGE 7
Stove Panel Assembly
1 Follow the directions below to install the side panels to the top panel.
Lay the top panel on a non-
scratching surface upside down.
Apply the two 6" long
gaskets along the
outside of the studs
Right side panel
Left side panel
Attach each Forward Mounting
Bracket with two 10-32 nuts.
Top panel
3/8" Nutdriver
a
b
c
d
Attach the side panels to the top panel with
the four 10-32 hex nuts (the smaller of the
two sizes) until the gasket compresses.
Do not over-tighten
the nuts – this may
cause damage to
the enamel finsih.
2 Follow the instructions below to install the side and top panels.
Apply high-temperature
silicone to the bottom of the
flue ring and
place it over the
vent (below the top panel).
High-Temp.
Silicone
Slide the top and side panels into
place, making sure they go
underneath the wires and gas line.
7/16" Wrench
Route the on/off switch and blower
wires to the right rear of the heater.
Attach the side panels to the heater
with four 1/4-20 hex nuts (reach in
from the rear of the heater with a
7/16" wrench to tighten).
Attach the forward brackets of
the top panel to the heater with
the two black screws.
Standard
Screwdriver
a
b
c
d
e