Specifications

PAGE 6 STOVE INSTALLATION - For qualified installers only!
Installation Preparation
! This appliance must be installed in accordance with all local codes, if any; if not, follow ANSI
Z223.1 and the requirements listed in this manual. Failure to follow all of the requirements
may result in property damage, bodily injury, or even death.
! Notify your insurance company before hooking up this heater.
! The requirements listed below are divided into sections. All requirements must be met
simultaneously. The order of installation is not rigid – the qualified installer should follow the
procedure best suited for the installation.
e
ms Packed with the Heater
• Avanti Gas Heater (with gold door)
• Propane Conversion Kit
• Log Set (2 Logs, 2 Twigs, Coals)
• Owner's Manual
• Strain Relief (for power cord)
• Strain Relief Bracket (for inserts only - may be discaded)
• 2 Gas Inlet Pipes (the longer one is for stoves)
e
ms Packed with the Pedestal Kit
• Pedestal
• Two 3/8 x 3/4" Bolts
• Two Washers
• Two Lag Bolts (these may be discarded)
e
ms Packed with the Stove Panel Kit
• Top, Left, Right, and Rear Stove Panels
• Control Cover
• Black Grill
• Flue Ring
• Eight 10-32 Hex Nuts with Attached Lock Washers
• Two 10-24 Pan Head Screws
• Twelve 10-24 Self-Tapping Screws
• Nine U-Nuts
• Two 6" strips of self-adhesive gasket
• Left & Right Forward Mounting Brackets
Order of Installation
1 If the heater is to use propane, install the propane
conversion kit (see pages 38 - 43)
2 Attach the pedestal
3 Attach the stove panels to the heater
4 Install the gas inlet (17-1/4" length of 3/8" pipe)
5 Position the heater (measure clearances from the upper
top), use floor protection if needed
6 Connect the gas line Connect the gas vent
7 Follow the instructions under "Finalizing the
Installation" on pages 20 through 26.
Pedestal Assembly
9/16" Wrench
Use a 9/16" wrench to
attach the two pedestal
bolts to the bottom of the
heater.
Lift from here
NOTE: Keep the heater
level to prevent the door
from shifting loose.
The lag bolts and washers
may be inserted through
these holes to anchor the
pedestal to the floor.