Specifications

PAGE 14 INSERT INSTALLATION (CONT.) - For qualified installers only!
Installing the Power Cord
1 The power cord may be located on either side. Place the insert power cord bracket (included with
the owner's pack) over the two studs and tighten with two 1/4-20 hex nuts (see illustration below).
Back of
Heater
Molex
Connection
7/16" Nutdriver
Disconnect the power cord, insert it through the bracketl, and
re-attach it to the molex connector leading from the heater.
Attach the strain relief bracket
with two 1/4-20 hex nuts.
2 Pull gently on the power cord to take out any extra slack. Attach the strain relief (it is shipped
attached to the power cord - see the illustration below).
Strain
Relief
Compress the
strain relief from
the top and
bottom and
insert it into the
hole until it locks
in place.
TO INSTALL THE
STRAIN RELIEF
Power Cord