Specifications

PAGE 6 STOVE INSTALLATION - For qualified installers only!
Installation Preparation
! This appliance must be installed in accordance with all local codes, if any; if not, follow
ANSI Z223.1 and the requirements listed in this manual. Failure to follow all of the
requirements may result in property damage, bodily injury, or even death.
! Notify your insurance company before hooking up this heater.
! The requirements listed below are divided into sections. All requirements must be met
simultaneously. The order of installation is not rigid Ð the qualified installer should follow
the procedure best suited for the installation.
Items Packed with the Heater
¥ Avanti Gas Heater (with gold door)
¥ On/Off Switch (with jumper wire attached)
¥ Log Set (2 Logs, 2 Twigs, Coals)
¥ Owner's Manual
¥ 2 Gas Inlet Pipes (the longer one is for stoves)
Items Packed with the Pedestal Kit
¥ Pedestal
¥ Two 3/8 x 3/4" Bolts
¥ Two Washers
¥ Two Lag Bolts (these may be discarded)
Items Packed with the Stove Panel Kit
¥ Top, Left, Right, and Rear Stove Panels
¥ Control Cover
¥ Black Grill
¥ Eight 10-32 Hex Nuts with Attached Lock Washers
¥ Two 10-24 Pan Head Screws
¥ Fourteen 10-24 Self-Tapping Screws
¥ Nine U-Nuts
¥ Two 6" strips of self-adhesive gasket
¥ Gas Line Plate
¥ Left & Right Forward Mounting Brackets
Order of Installation
1 Attach the pedestal
2 Attach the stove panels to the heater
3 Install the gas inlet
(17-1/4" length of 3/8" pipe)
4 Position the heater (measure clearances from the
upper top), use floor protection if needed
5 Connect the gas line Connect the gas vent
6 Follow the instructions under "Finalizing the
Installation" on pages 23 through 27.
Pedestal Assembly
9/16" Wrench
Use a 9/16" wrench to
attach the two pedestal
bolts to the bottom of the
heater.
Lift from here
NOTE: Keep the heater
level to prevent the door
from shifting loose.
The lag bolts and washers
may be inserted through
these holes to anchor the
pedestal to the floor.