User's Manual

4. Never repair the interior circuit to prevent destroying the inside electronic
components.
Troubleshooting
Problem Cause Solution
The indicator on the
transmitter does not light up.
The battery insulating film has
not been peeled off.
Peel off the insulating film.
The battery is not properly
installed.
Take out the battery and install it
again. Make sure the contacts are
good.
The battery power is low. Replace with a new battery.
The receiver does not respond
to the transmitter.
Unsuccessful pairing. Pair the transmitter and receiver
again.
FCC Caution
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
IMPORTANT NOTE:
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the