User's Manual

1. Adhesive tape: apply the double-sided adhesive tape on the back of the transmitter.
Remove the outer side of the tape and attach the transmitter in the desired location
on the wall and press hard for 30 seconds.
2. Screws and anchors: there are screw locator knockouts on the back of the
transmitter; punch these out to allow the screws to pass through and fix the
transmitter with the anchors in the desired location on the wall.
Operating Instructions
1. Plug a receiver into the power socket.
Pairing method
2. Press and hold the Volume button on the receiver for 3 seconds to enter the pairing
mode. The indicator will blink.
3. Press the Push button on the transmitter and the receiver will chime “ding dong”
to indicate the pairing is complete.
Notes
1. Press any button on the receiver or wait for 60 seconds to exit the pairing mode.
2. The receiver LED has a two-colorindicators with blue and red lights. The blue
indicator is the default light, and will illuminate during the first pairing. The red
indicator will illuminate during the second pairing. The two-color indicator will
alternate with the pairings.
There are 52 melodies for the doorbell kit. Press the Next button for the next melody
and the Previous button for the last one. You can easily choose your favorite chime
tone.
Melody selection
There are five volume levels in total and the minimum volume level is silent. Press
the Volume button to select a lower volume level. When the volume reaches its
minimum, press the button again it would turn to the maximum volume.
Volume adjustment
Notice
1. Please do not place this transmitter in areas close to metals.
2. The working distance varies with the blockagefrom different ambient
environments.
3. Use this product properly to prolong its lifespan.