Installation Sheet

Page 15
WALK-IN TUB MANUAL
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
5701 NW 35 Avenue Miami, FL 33142 • Phone [phone] • Fax [phone]
INSTALLATION AND EXTENSION PANELS
ASSEMBLY & PLACEMENT
Connect the two panels using pre-drilled holes:
Inner flange
Top panel
Side panel
Wall
Bathroom (Waterproof) Sheetrock
Mortar
Tile
Silicone
Screw*
*4mm screws
not included
2-piece extension panels
Molded flange to bolt unit to wall
Custom-built wall section(s) for open ends or
install against corners of full wall.
Every bathtub must be installed with a tile flange.
If the bathtub does have a tile flange then a tile
flange kit may be purchased separately.
Please call 305-614-4070 to inquire about the
tile flange kit.
The tile flange should be installed on the tub
before it is placed in the alcove. Install the tile
flange along all sides of the tub where the wall
will be. Measure to fit and miter cut the flange
corners. The flange should be attached to the
tub with a silicone adhesive.