Wireless Endoscope INSTRUCTION MANUAL Please carefully read this manual before using
Parts function Steering wheel Angulation locker Freeze button USB jack Power On/ Off Rec button Status indicator Toggle switch(wifi-usb) Light adjustment Charge jack(Micro usb) Start up Press the button to power on device , indicator lights will flash accordingly, turning the steering wheel to control distal end and navigate to objectives , by turning light adjustment wheel to get the brightness properly at camera head .
WIFI mode 1. Download & install APP Scan the QR code below or find ‘Mo-view’ at APP store (Apple or google play ), then download and install it . Get Mo-view icon on your phone QRcode 2. Put toggle switch on wifi side , push button , indicator light on blue , 3. Search wifi signal ‘ iscope _xxxxxx ’ and click it to connect the wifi successfully. Press Rec button to take phone or video recording (long press lasts for 3Sec) 4. Open the APP , then you will see the realtime video 5. Button allows to freeze frame .
1 2 3 4 1. Take photo 2. Take video 3. Playback 4. Resolution setting USB mode Put toggle switch on USB side , indicator lights on blue and green . Connect USB cable to PC, The image will be showed on PC sreen with Amcap or other video capture software If choose to connect smartphone (android ), please download and install the APP first , search ‘USB camera’ from google play store or scan QR code below to install on your phone .
Get USB CAMERA icon on your phone QR code Open the APP , you will see the real-time video and working interface as below : 1 2 5 3 4 1. Take photo 2. Take video 3. Playback 4 4. Resolution setting 5.
Charging 1.Left only one white light on indicates low power and need charging , please use 5V 1A USB charger. 2. During charging , some white light flashes , charging time lasts around 3hours when all three white lights on and no one flashes. 3. Built- in 3000mAh lithium Battery , can work for about 6 hours after fully charged .
Do not allow water come into contact with parts other then insertion tube ,water creates the risk of electic shock ,the parts of the instument other than insertion tube are not watertight,so the instrument should not be used or stored where it is submerged or wet. Do not use or store the instrument at a temperature higher than 50°C or lower than -10°C. Store the instrument in dry and adequately ventilated environment.
FCC Warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
