ERS-BYT Intel® Celeron® SoC Processor J1900 Fanless Rugged Embedded System Quick Reference Guide 1st Ed – 04 December 2014 Copyright Notice Copyright 2014 Avalue Technology Inc., ALL RIGHTS RESERVED. Part No.
ERS-BYT FCC Statement THIS DEVICE COMPLIES WITH PART 15 FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE. (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY WITH THE LIMITS FOR A CLASS "A" DIGITAL DEVICE, PURSUANT TO PART 15 OF THE FCC RULES.
Quick Reference Guide Content 1. Getting Started ............................................................................................................ 4 1.1 1.2 1.3 1.4 Safety Precautions ................................................................................................ 4 Packing List ........................................................................................................... 4 System Specifications ......................................................................
ERS-BYT 1. Getting Started 1.1 Safety Precautions Warning! Always completely disconnect the power cord from your chassis whenever you work with the hardware. Do not make connections while the power is on. Sensitive electronic components can be damaged by sudden power surges. Only experienced electronics personnel should open the PC chassis. Caution! Always ground yourself to remove any static charge before touching the CPU card. Modern electronic devices are very sensitive to static electric charges.
Quick Reference Guide 1.3 System Specifications System Mother Board ECM-BYT CPU Intel® Celeron® Processor J1900 Family BIOS AMI uEFI BIOS, 64Mbit SPI Flash ROM I/O Chipset EC (IT8528E) System Memory 1 x 204-pin SODIMM Socket Up to 8GB DDR3L 1333 SDRAM Watchdog Timer H/W Reset, 1sec. ~ 65535sec. Monitoring System Temperature, Voltage with Auto Throttling Control 1 x CF, 1 x 2.
ERS-BYT Power Type +12 ~ 26Vdc (Lockable DC Jack) Single Power ATX Support S0, S3, S4, S5 ACPI 3.
Quick Reference Guide 1.4 System Overview 1.4.
ERS-BYT 1.5 System Dimensions 1.5.
Quick Reference Guide 2. Hardware Configuration For advanced information, please refer to: 1- ECM-BYT User’s Manual Note: If you need more information, please visit our website: http://www.avalue.com.
ERS-BYT 2.1 ERS-BYT connector mapping 2.1.
Quick Reference Guide 2.1.2 VGA connector (VGA) PIN Signal PIN Signal PIN Signal 1 R 6 GND 11 NC 2 G 7 GND 12 DATA 3 B 8 GND 13 HSYNC 4 NC 9 +5V 14 VSYNC 5 GND 10 GND 15 CLK 2.1.
ERS-BYT 2.2 Installing Hard Disk & Memory Step1. Remove 10 screws from the rear side before removing back cover. Step2.1 Properly install the memory module and press until properly seated. Step2.2 Re-assemble your system back through previous steps to complete the installation.
Quick Reference Guide Step3.1 For HDD installation, please remove 4 screws to release the HDD bracket. Step3.2 Insert the HDD into the bracket and fasten 4 screws. Step4. Insert the HDD back and fasten 2 screws.
ERS-BYT 2.3 Installing CF Card Step 1. Unlock 2 screws from the rear side of the system. Step 2. Put the CF card into the socket and fasten 2 screws back.
