User Manual

User’s Manual
RSC-IMX51 User’s Manual
5
Contents
1. Getting Started ............................................................................................................ 7
1.1 Safety Precautions .................................................................................................... 7
1.2 Packing List ............................................................................................................... 7
1.3 Document Amendment History ................................................................................. 8
1.4 Manual Objectives ..................................................................................................... 9
1.5 System Specifications ............................................................................................. 10
1.6 Architecture Overview – Block Diagram .................................................................. 11
2. Hardware Configuration ........................................................................................... 12
2.1 Product Overview .................................................................................................... 13
2.2 Jumper and Connector List ..................................................................................... 15
2.3 Setting Jumpers & Connectors ............................................................................... 17
2.3.1 Battery connector (BAT1) ............................................................................................................... 17
2.3.2 GPIO Interface connector (JIO1) ................................................................................................... 17
2.3.3 Boot Mode selector (SW2) ............................................................................................................. 18
2.3.4 TTL Panel connector (CN3) ........................................................................................................... 19
2.3.4.1 Signal Description – TFT Panel Connector (CN3) ................................................................ 19
2.3.4.2 TTL cable wiring table ........................................................................................................... 20
2.3.5 Touch Panel Connector (CN10) ..................................................................................................... 21
2.3.6 Speaker_L/R connector (CN12) ..................................................................................................... 21
2.3.7 Line_In, MIC connector (CN14) ..................................................................................................... 22
2.3.8 Inverter Power connector & BL_PWM (CN19) ............................................................................... 22
2.3.9 12V Input connector (CN23) .......................................................................................................... 23
2.3.10 POE Module connector (CN26) ................................................................................................. 23
2.3.11 Power on LED connector (CN27) .............................................................................................. 24
2.3.12 I2C connector (CN28) ................................................................................................................ 24
2.3.13 Serial Port 2 connector (JCOM1) ............................................................................................... 25
2.3.14 LVDS Interface connector (JLVDS1) ......................................................................................... 26
2.3.15 USB 0&1 / 2&3 connector (JUSB1/JUSB2) ............................................................................... 27
2.3.16 Serial Port 1 connector (CN9) .................................................................................................... 27
2.3.17 Power on/off Switch connector (PSW1) ..................................................................................... 28
3. WinCE User Guide ....................................................................................................... 29
3.1 Installing Windows Embedded Tools and RSC-IMX51 BSP ................................... 30
3.2 ATK Tool Installation & Setup ................................................................................. 31
3.3 Preparing for Downloading and Debugging ............................................................ 32
3.4 Program XLDR and EBOOT in on-board flash Using ATK Tool .............................. 33
3.5 Initialize EBOOT Network Configuration ................................................................. 34
3.6 Configuring Ethernet Connection for Downloading and Debugging ........................ 35