Installation manual

54 Finalizing the Installation (for qualified installers only)
Travis Industries 4050714 100-01173_001
5 Replace the rear burner. Set the rear burner air shutter to a 3/16" gap.
This gap is the air shutter opening.
Rear Burner Air Shutter
Loosen the screw on the air
shutter and rotate the air shutter.
For LP Units:
Start with the rear air shutter
set to a 3/16" opening.
6 Replace the firebox
components. Install the
logs and embers.
Replace the glass.
7 Remove the regulator
from the front of the gas
control valve. Replace
with the propane
regulator, using the new
gasket and screws
included with the
regulator. NOTE: Leak
test this area after the
heater is installed, gas
is connected, and the
main burner is lit.
Remove and discard the three
screws using a slotted screwdriver
of Torx T-20.
NOTE: Make sure the
regulator gasket is correctly
aligned before installation.
Remove and discard the
regulator, diaphram, spring
and center post.
a
b
Slotted
Screwdriver
(or T-20 Torx)
Install the LP regulator. Use
the screws included with the
LP regulator. Tighten to
approximately 25 Lbs. torque.
c
Slotted
Screwdriver
(or T-20 Torx)
Place the LP
label on the base
of the fireplace
near the gas
control valve.
d