Installation manual

54 Finalizing the Installation (for qualified installers only)

LP Conversion Instructions

Install the conversion kit prior to installing the gas line to ensure proper gas use.

1 Remove the glass (see page 43). Remove the logs and embers (if installed - page 47)

2 Remove the burners following the directions below.

Lift the rear burner, slide it to the right, and lift it from the firebox. The burner has a bracket that

inserts over two pins behind the burner. When replacing the burner make sure it is properly located.

Lift the front burner, slide it to the right, and lift it from the firebox. When replacing the burner make sure it is

properly located.

The rear burner air shutter support will need to be removed to access the orifice. Remove the support and

place it aside.