Installation manual

62 Optional Equipment (for qualified installers only)

17 Attach the included velcro to the bottom of the fan control module and to the base of the fireplace

near back left of the fireplace. Slide the fan controller into place and secure using the velcro

(see Figure 26).

Figure 26

18 Pull the “RECEIVER” connector through the control panel and attach to the receiver (see Figure

27). Then attach the receiver to the control panel with the two #8 machine screws (see Figure

28).

Figure 27

Figure 28

19 Place batteries into the receiver and transmitter (see Figure 29). Calibrate the receiver to the

transmitter (see Figure 30 - use a paperclip to press the “PRG” button, let it beep, then press any

button on the transmitter – the receiver should beep 5 times – see the operating instructions for

further details).

Figure 29

Figure 30