Installation manual

Optional Equipment (for qualified installers only) 59

9 Use the included torx wrench to remove the stock regulator (see Figure 13). These items may be

discarded.

Figure 13

10 The stepper motor (adjustable regulator) has an installation sheet included with it – make sure to

follow all of the directions. Place the stepper motor on the gas control valve (see Figure 14) –

MAKE SURE IT IS CORRECTLY ORIENTED. Secure using the screws included with the motor

(see Figure 15) – tighten to 25 Lb-inches. Leak test this area after installation to verify proper

installation.

Figure 14

Figure 15

11 Place the GreenSmart wiring harness in front of the fireplace, noting the position of each

connector (see .Figure 16).

Figure 16