Installation manual

Optional Equipment (for qualified installers only) 57

3 Unplug the ac adapter from the power harness (see Figure 4). You can leave the ac adapter

plugged into the wiring harness.

Figure 4

4 Disconnect the molex connector leading to the gas control valve (see Figure 5).

WARNING: The tabs on the gas control valve are fragile. Take care when removing the molex

connector to not pull or damage the wires or tabs.

Figure 5

5 Disconnect the two leads on the back of the control panel for the IPI / CPI switch (continuous pilot

/ greensmart pilot – see Figure 6).

Figure 6