Installation manual

56 Optional Equipment (for qualified installers only)

Installation

WARNING: Make sure power to the fireplace has been shut off prior to installation.

NOTE: Refer to the wiring diagram on page 62 while making wiring harness connections.

Special Instructions for this Fireplace

If using the Greensmart™ remote, the blower included with this fireplace should be attached to a

power lead (included with the remote) and connected to the Fan Controller (see wiring diagram

on previous page). See the remote installation instructions for further details. In addition,

bypass the blower rheostat following the directions below.

Bypassing the Rheostat - In

addition, you will need to bypass

the rheostat (the remote

controls the blower). This is

done by disconnecting and

discarding the electrical line that

leads from the snap disk to the

rheostat (carefully remove the

wire tie from the wiring harness

– see “a”). Attach the lead from

the power input to the snap disk

(see “b”).

1 Remove the concealment cove (see Figure 1).

Figure 1

2 Unscrew the four screws holding the control cover in place (see Figure 2). Carefully remove the

control cover (see Figure 3)

Figure 2

Figure 3