Installation manual

50 Installation (for qualified installers only)

6 Install the new manifold cover included in the LP conversion kit (see illustration below).

7 Remove the pilot orifice following the instructions below. Replace with the propane pilot orifice

Lift the pilot hood

off the pilot

assembly.

5/32" Hex

Use a hex wrench to

unscrew the orifice.

Remove the orifice and replace with the LP orifice. Screw the

orifice all the way in and replace the pilot hood.

LP (Propane) Orifice

Orifice Identification:

NG (Natural Gas) Orifice

NOTE: when re-attaching,

this pin lines up with the

notch in the pilot hood.

8 Replace the burner. Push the burner to the right side to insure the manifold inserts over the

orifices.

9 Install the rivet included in the LP conversion kit into the hole shown below.