Installation manual

Installation (for qualified installers only) 37

Steps for Finalizing the Installation

1. Remove the glass frame (see page 39).

NOTE: If using propane (LP) convert the appliance prior to installing the logs.

2. We recommend you purge the gas line at this time (with the glass frame removed). This allows gas to be

detected once it enters the firebox, ensuring gas does not build up.

3. Make sure the two accent light bulbs are in place.

NOTE: Take care to not touch the bulb with your fingers (use a cloth or paper towel).

4. Install the required firebacks (see page 41).

5. Place the grate inside the firebox. Slide it back so it contacts the burner (see the illustration above).

6. Install the logs (see page 39)

7. Replace the glass frame.

8. Install the four AA batteries (included in the owner’s pack) into battery holder (see the illustration below). The AA

batteries act as a power backup in case the household (AC) power goes out. Install the 9v battery (included in

the owner’s pack) into control panel light assembly (see the illustration below). The battery holder is held in place

with Velcro and may be removed for easier access.

AA Battery

Lift up and swing the lower

grill down to acces the area

below the firebox.

Swing the concealment

cover up and slide it back to

expose the controls.

Battery

Holder

AA Battery Tray

AA Battery

Battery

Battery Holder for

Control Panel Lights