Owner`s manual

Installation (for qualified installers only) 23

Steps for Finalizing the Installation

1. Remove the glass (see page 25).

NOTE: If using propane (LP) convert the appliance prior to installing the logs.

2. We recommend you purge the gas line at this time (with the glass removed). This allows gas to be detected

once it enters the firebox, ensuring gas does not build up.

3. Make sure the accent light bulb is in place.

NOTE: Take care to not touch the bulb with your fingers – use a cloth or paper towel).

4. Install the four AA batteries (included in the owner’s pack) into battery holder (see the illustration below). The AA

batteries act as a power backup in case the household (AC) power goes out. Install the 9v battery (included in

the owner’s pack) into control panel light assembly (see the illustration below). Velcro is provided to secure the

9v battery.

AA Battery

Swing the control

cover down to

access the

batteries.

Battery

Holder

AA Battery Tray

AA Battery

Battery Holder for

Control Panel Lights

Battery