Service manual

Installation Instructions for 45HW & 47HW Electrified Mortise Locks
BEST ACCESS SYSTEMS
a Division of Stanley Security Solutions, Inc.
15
Installation Instructions for 45HW & 47HW Electrified Mortise Locks
Finishing the installation
21 Install door status magnet
(optional for deadbolt function locks)
1 On the door jamb, mark the drill point for the door
status magnet hole.
Note: This hole should be directly opposite the door
status switch when the door is closed.
2 Drill a 1″ diameter hole for the magnet, at least 1 3/4″
deep.
3 Insert the magnet into the hole.
22 Install cores
1 For a high-security cylinder, slide the cylinder face
down over the core.
2 Insert the control key into the core and rotate the key
15 degrees to the right.
3 With the control key in the core, insert the core and
cylinder face (high-security cylinder only) into the
cylinder.
4 Rotate the control key 15 degrees to the left and
withdraw the key.
Caution: The control key can be used to remove
cores and to access doors. Provide adequate
security for the control key.
Figure 21 Installing the door status magnet
Door
status
magnet
Figure 22 Installing the core(s)
Control key
Core
Cylinder
Cylinder face
View of high-security cylinder