Service manual

BEST ACCESS SYSTEMS
a Division of Stanley Security Solutions, Inc.
1
Contents
These installation instructions describe how to install your
45H & 47H Mortise Lock. Topics covered include:
Finishing the door preparation ...................................... 1
Configuring and installing the mortise case................. 3
Installing the trim............................................................ 5
Finishing the installation..............................................11
For instructions to install 45HW & 47HW electrified
functions, see the Installation Instructions for 45HW &
47HW Electrified Mortise Locks (T81612).
1 Identify holes to drill
1 Determine the lock function to be installed.
2 Determine the inside and outside, hand, and bevel of
the door.
3 See the Holes by Function table and Figure 1 to
determine the holes to be drilled for the lock function.
Figure 1 Identifying holes to drill
A
B
C / D
FE
G
G
H
A
E
For hole sizes, see the
H15 Template (T81163).
JJ
Installation Instructions for
45H & 47H Mortise Locks
Functions
Holes by Function
A, D, R,
RHB, B5
AB, AT, B, BA,
BW, HJ, T, TA, TD
AD
C, CHB, G, IND,
INL, S, W, B7
H L, LB, LT N, NX RD, WD YD
Holes to drill
I/S O/S I/S O/S I/S O/S I/S O/S I/S O/S I/S O/S I/S O/S I/S O/S I/S O/S
A M & N forged trim
(2 holes)
†
† Determine trim holes based on trim type.
Through
door
Through
door
Through
door
Through
door
Through
door
Through
door
Through
door
Through
door
Through
door
B J trim
†
Through
door
Through
door
Through
door
Through
door
Through
door
Through
door
C Standard cylinder or
D High security cylinder
‡
‡ To qualify for the UL 437 high security listing, use the M escutcheon and the 1E7J4 cylinder. The 1E7K4 cylinder is available for use with
either M trim or sectional trim, but does not qualify for the UL437 high security listing. This option is not available for H and HJ function locks.
■■■■■ ■ ■■ ■
E H, R & S trim thumb turn
mounting screw (2 holes)
†
■ ■ ■ ■
F Emergency key /
thumb turn access
■ ■ ■ ■■■
G Trim mounting
(2 holes)
††
■
■■■ ■■■ ■■■■ ■
H Lever
††
■ ■■■ ■■■ ■■■■ ■
J H & R trim visual indicator
mounting screw (2 holes)
†
■
†† Because these holes pass through the mortise pocket, it is recommended that each hole be drilled separately rather than straight through.