Owner`s manual

Installation (for qualified installers only) 9

Installation Hints:

• Recommended Optional Equipment Installation Order:

-- GreenSmart Remote

-- Blower

-- LP Conversion and other optional equipment

• Install the logs last - they are fragile.

• When determining the location of the stove, locate the wall studs (for horizontal penetrations) and

ceiling trusses (for vertical penetrations). You may wish to adjust the stove position slightly to ensure

the vent does not intersect with a framing member.

• Fumes and smoke from the paint curing and oil burning off the steel may occur the first time you start

this heater. This is normal. We recommend you open windows to vent the room.

Stove Clearances

NOTE: If using the rear vent configuration, you will require approximately

8-1/2” to the rear of the stove for the vent adapter and thimble. See page

18 for details.

3-1/2" Min.

89mm

Straight Installations Corner Installations

With this clearance, the vent is

centered 10-1/4" (260mm)

from the wall.

With this clearance the top vent is

centered 8" (203mm) from the

back wall, 14-1/4" (362mm) from

the side wall.

5" Min.

127mm

(See note above

regarding rear vent

configurations)

1" Min.

25mm

45°

Mobile Home Requirements

• When the stove is installed in a mobile home, it must be bolted to the floor and the appliance

grounded (use the optional blower with a grounded circuit or other suitable grounding method -

current ANSI/NFPA 70 or CSA C22.1).