Owner`s manual

Optional Equipment (for qualified installers only) 51

Installation

WARNING: Make sure power to the stove has been shut off prior to installation.

NOTE: Refer to the wiring diagram on page 50 while making wiring harness connections.

1 Loosen the bottom panel attachment screws (there are two on each side see Figure 1). Slide the

bottom panel back and place it below the stove (see Figure 2). This allows for access to the controls

under the stove. NOTE: The fireplace controller is secured to the panel with Velcro. It may be

removed to allow the panel to rest on the ground.

Figure 1

Figure 2

2 Remove the four screws holding the control panel to the front of the stove (see Figure 3). Carefully

remove the control panel, making sure you do not disconnect any wiring (see Figure 4).

Figure 3

Figure 4