Owner`s manual

Installation (for qualified installers only) 21

Rear Vent Configuration Vented into Fireplace with Co-Linear Adapter

• Attach the Co-Linear adapter directly to the back of the stove. Use two (2) 3” flex vents to vent

the appliance through a code-conforming masonry or metal (zc) fireplace. All clearances to

combustibles must be met and the flex vent must be vented through a non-combustible fireplace

chimney.

• Use a high-wind termination cap.

• Vent height must be a minimum 10’ and maximum 25’.

• Diffuser must be set to closed (#2) position.

• Intake and exhaust restrictor must be set to the #1 (stock) position.

• Do not install the intake damper plate or exhaust restrictor extender plates.

Flashing and Adapter

#991 High Wind

Termination

Co-Axial to Co-Linear Adapter

High-Temp.

Silicone

3" (77mm) Dia. Flex Line

Min. 18"