Owner`s manual

18 Installation (for qualified installers only)

Rear Vent Configurations with Horizontal Termination and No Rise

• Use 8” Diameter Vent with a 6-5/8” to 8” adapter (increaser). We recommend using the minimum

vent kit from Travis Industries (SKU 96200311). This kit contains the following components used

to vent the stove through a typical exterior wall:

-- 6-5/8” to 8” Adapter (Black)

-- Thimble

-- Thimble Cover (Black)

-- Pipe (3.9”)

-- High-Wind Horizontal Cap

• Place the 6-5/8” to 8” adapter directly onto stove (see illustration below).

• Maximum Horizontal Run of 4’.

• Horizontal sections require a ¼” (6mm) rise every 12” (305mm) of travel.

• Maximum of one (1) 45° elbow may be used between horizontal sections.

• Diffuser must be set to closed (#2) position.

• Intake and exhaust restrictor must be set to the #1 (stock) position.

• Do not install the intake damper plate or exhaust restrictor extender plates.

6-5/8" to 8" Adapter

High Wind Horizontal Cap

Required (58DVA-HC)

Typical 8-1/2" (216mm)

Min. 12" (305mm)

Grade

Thimble w Cover

Max. 4' (1.2M)