Installation manual

GreenSmart™ Remote (2010 Version)
SKU 99300685 (NG) SKU 99300684 (LP)
Page 9 of 14 4/14/11 - 17601643 © Travis Industries, Inc.
Direct Fireplace Operation
The fireplace may be directly operated from the receiver. The three positions are below (see Figure 5):
ON
– Fireplace burner turns on (regardless of transmitter settings).
OFF
– Fireplace burner turns off (regardless of transmitter settings).
REMOTE
– Fireplace is controlled by the transmitter.
ON
REMOTE
OFF
PRG
Figure 5
NOTE: When the receiver switch is turned to ON or OFF, the mode settings (Accent Light, Blower, Flame
Height, Comfort Control) will remain in the same state as before the switch was moved (i.e.: the receiver
“remembers” the last setting). If you wish to adjust the mode settings use the transmitter mode button to
adjust the settings (see “Mode Controls” on page 12). The thermostat and burner on/off operating
functions will not work on the transmitter.