Installation manual

GreenSmart™ Remote (2010 Version)

SKU 99300685 (NG) SKU 99300684 (LP)

Page 8 of 14 4/14/11 - 17601643 © Travis Industries, Inc.

Set-Up

Verify the Fan Control Module is On

The fan control module has a power switch. Make sure it is in the ON (“-“) position (see Figure 3). This

switch must remain in the ON position for the AC components to operate (Accent Light and Optional

Blower). The module also supplies low-voltage for the fireplace controller. By leaving it in the OFF

position, the fireplace will operate off the receiver batteries, greatly diminishing battery life.

”

Figure 3

Synchronize the Transmitter to the Remote

The transmitter will need to be synchronized to the receiver before the remote will work correctly.

Synchronizing is done in the following two steps below (see Figure 4):

a) Press the PRG (Program) button on the receiver using a paperclip or equivalent device (receiver

will beep 3 times).

b) Press the “ON” button on the transmitter (receiver will beep 4 times).

°F

"Beep"

“Beep”

Figure 4

NOTE: If power is cut off to the receiver for an extended period of time, you may need to re-synchronize

the remote.