Installation manual

GreenSmart™ Remote (2010 Version)
SKU 99300685 (NG) SKU 99300684 (LP)
Page 11 of 14 1/11/12 - 17601643 © Travis Industries, Inc.
Manual On-Off / Smart Thermostat / Standard Thermostat
Use the thermostat button to cycle through the three thermostat settings (see Figure 8).
OFF
ON
SMART
ON
F
AUXMAX
Look here for the
thermostat setting.
Press the thermostat button to cycle
through the thermostat settings.
Figure 8
 MANUAL ON/OFF – The burner will turn on and off using the remote (see Figure 9). Press the
On/Off button to control the burner. When off, the display will only show the current temperature.
OFF
F
AUXMAX
When in manual setting, the
word “OFF” will appear here.
MAX
Figure 9
 SMART THERMOSTAT – While in smart thermostat, the transmitter will control the flame height
to achieve the target temperature (“smart modulation”). If the temperature exceeds the target
temperature the heater will shut off. This allows the heater to stay on longer and provide a more
consistent temperature. To adjust the target temperature, press the up and down buttons until a
suitable temperature is achieved. (see Figure 10 below).
F
AUXMAX
When in smart thermostat
setting, the word “SMART”
will appear here.
This is the target temperature
on the read-out. Use the up
or down buttons to adjust the
target temperature.
SMART
Figure 10
 STANDARD THERMOSTAT - While in standard thermostat setting, the transmitter will turn the
burner on and off to achieve the target temperature (see Figure 11 below). To adjust the target
temperature, press the up and down buttons until a suitable temperature is achieved.
ON
F
AUXMAX
When in standard thermostat
setting, the word “ON” will
appear here.
This is the target temperature
on the read-out. Use the up
or down buttons to adjust the
target temperature.
Figure 11
NOTE: if the transmitter batteries go dead while in thermostat setting (standard or smart), the appliance
will shut off after approximately 24 hours.