Installation manual

GreenSmart™ Remote (2010 Version)
SKU 99300685 (NG) SKU 99300684 (LP)
Page 10 of 14 4/14/11 - 17601643 © Travis Industries, Inc.
Remote Operation
Once the receiver is switched to “REMOTE” the transmitter operates the fireplace. Once you understand
how the transmitter works, you will be able to operate your fireplace quickly and easily.
Display Overview
The transmitter display has four main sections (see Figure 6).
ON
F
MAX AUXMAX
Thermostat Display
Room Temperature Display
Read-Out (Thermostat Setting, Function, etc.)
Mode Display (Flame Height, Blower, Light, Comfort Control)
Figure 6
Listen for the “Beep”
Each time you press a button on the transmitter that controls the fireplace, a “beep” will come from the
fireplace. When you change thermostat target settings the fireplace will not beep.
NOTE
: When the receiver batteries start to get low, the receiver will beep intermittently. When the
batteries are nearly depleted, the receiver will no longer beep. See “Receiver Batteries” on page 14).
ON / OFF Operation
The top button on the remote turns the remote on and off (see Figure 7).
ON
– Remote controls the fireplace (make sure receiver is in REMOTE position - see Figure 5).
OFF
– Fireplace will remain off (make sure receiver is in REMOTE position - see Figure 5).
F
OFF
ON
OFF
OFF
F
AUXMAX
MAX
ON
Figure 7