Owner`s manual

Optional Equipment 33
© Travis Industries 100-01252_000 4101004
Rear Blower Installation (Part # 99000138)
The rear blower improves heat transfer by pushing heated air
through the convection channel. Operating instructions are
described in the section "Blower Operation".
1 On some models you will need to remove the two
knockouts under the stove (see illustration to the right).
2 Follow the directions below to install the thermodisk.
Front of Stove
Bend these legs on
the snap disk if it
does not fit tightly
Wedge the snap disk into the
air chamber on the left side 6”
from the front.
Twist the wires together and feed them
through the convection chamber and
out either knockout.
Snap Disk
Assembly
3 Install the wire clip following the directions below.
Slide the wire clip
over the edge of the
strip of metal between
the two knock-outs.
Feed the two snap disk wires into
the eye of the wire clip. Remove
all slack from the wire, making
sure not to dislodge the snap disk.
Pinch the eye of the wire clip to
secure the wires.
Wire Clip
Snap Disk
Wires
WARNING:
To prevent electrical shock, the
wires must be secured so they do
not contact the firebox above the
convection channel.
4
Attach the blower
following the
directions to the
right.
3/8" Wrench
Plug the blower in. Do not route the
power cord under or over the stove
or in a location where it may become
damaged.
Position the blower near the rear of the stove. Connect the
snap disk wires to the blower wires and tuck all excess wire
into the blower box, making sure it does not contact any hot or
moving parts. When installing the blower, make sure these
wires do not become loose. Attach the blower to the stove with
the three screws included with the blower.