Operating instructions

Pellet Heater Operating and
Troubleshooting Instructions
Page 6 of 9 Printed 8/13/08
Manual Mode
Manual mode requires the user to turn the heater on and off
manually.
To Start
Press the "Manual Start" button. That's it. The stove
automatically goes to a medium burn rate and high fan while
the igniter starts the fire burning within 10 minutes. During
this period the lowest “HEAT OUTPUT” light will flash. If the
stove does not start in 30 minutes, the stove turns off.
Once up to temperature, the stove will then run at the heat
output setting selected on the control panel (see “To Adjust
the Heat” below).
AUTO
OFF
MANUAL
H
E
A
T
F
A
N
UP
DOWN
UP
DOWN
MANUAL
MANUAL
START
AUGER
TRAVIS INDUSTRIES
HOUSE OF FIRE
TM
To Shut Down
Move the mode switch to "OFF". The exhaust blower will still
run until the heater cools down.
AUTO
OFF
MANUAL
H
E
A
T
F
A
N
UP
DOWN
UP
DOWN
MANUAL
MANUAL
START
AUGER
TRAVIS INDUSTRIES
HOUSE OF FIRE
TM
To Adjust the Heat
Press the "Heat” buttons to adjust the heat output.
NOTE: During start-up you may adjust the heat setting. This
heat setting will take affect once the start-up sequence is
complete.
HIGH
DISCONNECT POWER BEFORE SERVICE
AUTO
MANUAL
H
E
A
T
O
U
T
P
U
T
MED
LOW
AUGER
MAINT.
AUTO
OFF
MANUAL
H
E
A
T
F
A
N
UP
DOWN
UP
DOWN
MANUAL
MANUAL
START
AUGER
TRAVIS INDUSTRIES
HOUSE OF FIRE
TM
(REQUIRED)
These lights
indicate the
heat output
setting.
NOTE: the
lights may
be difficult to
see from an
angle.
Press the
“up” or
“down”
button to
adjust the
heat output.