Use and Care Guide

15
Flushing Filters Prior to Use
Before continuing with installation, it is recommended
that you flush both filters for approximately 2 minutes.
1. Disconnect the Sediment Filter from its
Adapter by rotating it counter clockwise and
twist the filter into the provided Filter Flushing
Adapter by rotating it clockwise.
3. Hold the filter with the Filter Flushing
Adapter in place over a sink. Turn the Valve of
the Metal Adapter at the water source to the
on position (the on position is parallel to the
Tubing) and allow the water to flow through
the adapter and the filter for approximately 2
minutes to flush the new filter.
2. Take the open end of the PE Tubing
that is now connected to your water
supply and insert it into the left inlet
hole on the Filter Flushing Adapter in
the direction of the arrow.
4. Turn the Valve of the Metal Adapter
at the water source back to the o
position, remove the filter from the
Filter Flushing Adapter.
Getting Started