Installation Guide
Water leakage.
If the appliance is making a soud, there should be leakage. Please check
the PCB on the palte. Repair the machine and dry the PCB, and then
power on agin.
Pipe not connected properly.
Inspect the adapter to connect the pipe properly.
Water pipe and PE pipe bursng.
Replace the water pipe.
7
.
Nightlight isn't working.
Make sure the power cord is properly connected to a working outlet.
Make sure nightlight power switch on back of dispenser is ON.
Dispenser is noisy.
Make sure the dispenser is posioned on a level surface.
Small water flow.
Low water pressure.
Check the water inlet.
The filter exceeded it's usage me.
Please contact the manufacturer to replace the filter
Please allow 15 minutes for the hot water to be heated. During this me
the will be steady. The light will turn off when the green heang pilot lamp
heang process is complete. Please allow 90 minutes for the cold water
to be cooled. During this me the will be steady. green cooling pilot lamp
The light will be turned off when the cooling process is complete. If any
error occurs in the heang or cooling process, the indicator light will blink.
Activate Nightlight
Push top side of blue power switch in to turn light on. Push boom side in to
turn light off.