Installation Guide
The total flow above is for reference only. It is based on normal water use.
The specific cycle for replacement of filters varies with local water quality
and
water amount consumed.
function
Reduce Chlorine, Taste and odor, Nominal
particular class I, Lead and Cysts.
Special hints:
Filter replacement cycle
6
replacement
6 Months or 1500 gallons
9. Turn back on the valve from the water source.
10. Turn on the blue valve to the le of the filter.
11. Flowchart of water generaon
12. Aer installaon of water line and filter, plug the power cord into a grounded
power supply and begin to use machine normally.
Please note, if you wish to skip the Filter Flushing Instrucons Prior to the First
Use, you can do the regular installaon and then just let the water flow from the
cold water spout for approximately 5 minutes to flush out the new filter.
Tap water
PE pipe
Water inlet
D: TROUBLE SHOOTING
No water is coming from the spout.
Make sure to completely depress the push buon controls.
Cold water is not cold.
It takes up to one hour aer setup to dispense cold water.
Make sure the power cord is properly connected to a working outlet.
Make sure the back of the dispenser is at least 20 cm from a wall and there is
free airflow on all 20cm sides of the dispenser.
Make sure green power switch on back of dispenser is ON.
If water sll isn't cold, please ask a service agent for assistance.
Hot water is not hot.
It takes 15-20 minutes aer setup to dispense hot water.
Make sure the power cord is properly connected to a working outlet.
Make sure red power switch on back of dispenser in ON.