Installation Guide

3. Unpack the product, install the drip tray.
4. Take out the quick joint adapter with valve and install it on the water pipe.
Intall the adapter:
1. Disconnect the current cold water supply line, as in figure 1.
2. Connect the adapter with valve to the cold water supply line, as in figure 2.
3. Connect the nut on the side of the metal adapter and insert the PE Tube
pipe
through the nut. Sck the PE Tube pipe over the side part of the
adapter where
the nut was originally, as in figure 3.
4. Crew the nut ghtly into place keeping the PE Tube pipe securely
connected to
the adapter with valve, as in figure 4.
5. Note: Do not connect this water line to hot water supply line.
Filter Flushing Instrucons Prior to the First Use
1. Before connecng the other end of the PE tubing to the back of the water
cooler, connect it to the provided A4 System filter flushing adapter into the
le inlet hole in the direcon of the arrow on the adapter.
2. Twist the replacement filter into this A4 System filter flushing adapter unl
it is in place.
Inlet
Metal Adapter with
Valve
PE Tube (3m)
Mounng Bracket
Elbow Connector and Tube
Electronic Valve Connector
and Tube
Extra Filter Flushing
Adapter
Tape and Tools (not included)
Tape and Tools (not included)