Installation Guide
9
4. To Remove Mineral Deposits
Mix 4 L of water with 200 g of citric acid crystals, pung the mixture into the
machine making sure the water can flow out of the hot water tap. Switch on
the power and heat it for about 10 minutes. 30 minutes later, drain the liquid,
then clean it with water two or three mes. Never disassemble by yourself to
avoid damaging machine. Generally this should be done every six months.
5. Maintenance of Filtraon System
2) The dispenser heats water to a temperature of approximately 185 F.
It can cause severe burns. Please operate it carefully.
3. Sanizing
This machine should be sanized with a disinfectant and then cleaned with
water every three months. (See cleaning and draining instrucons.)
1) When lifeme of the filter is near its end, either by means of water flow or
by means of 6 months me, the red indicator light on the right side of the
front panel will blink red as a warning.
2) When the filter lifeme is up, the indicator light will be steady red.
3) Shut off the valve at the water source or the valve to the le of the filter
inside the cabinet.
4) Twist out the old filter from the A4 system inside the water cooler cabinet.
CAUTION: The cycle takes 90 minutes to complete. During this me
do not dispense and drink the water. We recommend you do this
during a period when the dispenser will not be in use like overnight
or when staff is away from the office. During the cycle you may smell
some ozone.
6.
Acvate Self-Cleaning Funcon
Every week use the self-cleaning feature to sanize tanks and water lines.
To acvate, press in the self-cleaning switch, hold for 5 seconds and release.
The green indicator light on the le will begin blinking, indicang the
cleaning process is underway. Ozone will be produced and injected into the
water system. It will kill bacteria and bio-films typically found in water
dispensers. By the end of the cycle the ozone will convert to harmless oxygen
and be emied into the air.
5) Twist the new filter into the A4 system built into the water cooler cabinet.
6) Turn back on the valve from the water source or the valve to the le of the
filter inside the cabinet.
7) Only replace the filter with a new Avalon filter designed for this water cooler.
Any other type of filter will damage the machine and void any warranty.
8) Aer replacing the filter, press the filter reset buon on the inside of the
cabinet, unl the red light turns off.
9) Allow water to flow from the cold water spout for approximately 5 minutes
to flush the new filter.
10) Please refer to the addional filter instrucons for further details.