Installation Guide

8
Aer setup, hot water will be available in 15-20 minutes.
1. Posion bole, glass, pitcher, or cooking pot below spout.
2. Slide red buon away from you and depress hot water push buon downward
to start hot water flow.
3. Release push buon once desired fill level is achieved.
push buon
push buon
E: WATER PURIFIER
F:CLEANING
1. To avoid accidents, cut off the power supply before operaon
according to the following instrucons.
2. Aenon:
1)
Cleaning must be performed by someone with experience or an
authorized service agent.
1)Make sure the power switch in the O(off) posion and unplug the
water dispenser before cleaning.
2)Unscrew the two screws from the back of the unit as in figure 1.
3)Remove the top cover, cold tank cover,
and separator as in figure 2.
4)Fill 1L of pure water into cold tank (the open cylindar that the cover
was removed from) to clean it.
5)Place a large water bucket beneath the outlet of hot water which
is in the back of the water dispenser , then remove the drain cover
and drain the water as in figure 3.
6)Reposion the drain cover, separator, cold tank cover, and top
cover aer draining. Ensure the pipe and wires are connected
properly, then you can use the machine normally.