Full Product Manual
F:CLEANING
1. To avoid accidents, cut off the power supply before operaon according
to the following instrucons.
2. Aenon:
1)
Cleaning must be performed by someone with experience or an
authorized service agent.
2) The dispenser heats water to a temperature of approximately 185 F.
It can cause severe burns. Please operate it carefully.
Aer setup, hot water will be available in 15-20 minutes.
1. Posion bole, glass, pitcher, or cooking pot below spout.
2. Slide red buon away from you and depress hot water push buon downward
to start hot water flow.
3. Release push buon once desired fill level is achieved.
8
1)Make sure the power switch in the O(off) posion and unplug the water
dispenser before cleaning.
2)Unscrew the two screws from the back of the unit as in figure 1.
3)Remove the top cover, cold tank cover,
and separator as in figure 2.
4)Fill 2.2 L of pure water into cold tank (the open cylindar that the cover
was removed from) to clean it.
5)Place a large water bucket beneath the outlet of hot water which is in
the back of the water dispenser (part no. 14), then remove the drain
cover and drain the water as in figure 3.
6)Reposion the drain cover, separator, cold tank cover, and top cover
aer draining. Ensure the pipe and wires are connected properly, then
you can use the machine normally.