Use and Care Manual

6
1. The machine was disinfected before being shipped from the factory. Clean
the
dispenser prior to installing a full bole of water for the fist me.
2. Cleaning and draining instrucon:
1)Make sure the power switch in the O(off) posion and unplug the water
dispenser before cleaning.
2)Twist out the two screws, the take down top cover, cold tank cover,
and separator
3)Fill 2.2 L of pure water into cold tank to clean it.
4)Place a large water bucket beneath the drain outlet which is in the back of
the water dispenser, then remove the drain cover and drain the water.
5)Reposion the drain cover, separator, cold tank cover, and top cover aer
draining. Ensure the pipe and wires are connected properly, then you
can use
the machine normally.
CLEANING
To avoid accidents, cut off the power supply before operaon according
to the following instrucons.
TROUBLE SHOOTING
Water is leaking.
Unplug dispenser, remove bole and replace it.
No water is coming from the spout.
Make sure the bole is not empty. If empty, replace it.
Make sure to completely depress the push buon controls.
Cold water is not cold.
It takes up to one hour aer setup to dispense cold water.
Make sure the power cord is properly connected to a working outlet.
Make sure the back of the dispenser is at least 20 cm from a wall and
there is free airflow on all 20 cm sides of the dispenser.
Make sure green power switch on back of dispenser is ON.
If water sll isn’t cold, contact an authorized service agent.
Hot water is not hot.
Dispenser is noisy.
It takes 15-20 minutes aer setup to dispense hot water.
Make sure the power cord is properly connected to a workin
g outlet.
Make suer red power switch on back of dispenser is ON.
Make sure the dispenser is posioned on a level surface.