Use and Care Manual

7
Aenon:
1)
Cleaning must be performed by someone with experience or an
authorized service agent.
2) The dispenser heats water to a temperature of approximately 185 F.
It can cause severe burns. Please operate it carefully.
3. Sanizing
Mix 4 L of water with 200 g of citric acid crystals, pung the mixture into the
machine making sure the water can flow out of the hot water tap. Switch on
for about 10 minutes. 30 minutes later, drain the liquid,
the power and heat it
o
Never disassemble by yourself to
or three mes.
then clean it with water tw
machine
. Generally this should be done every six months.
avoid damaging
4. To Remove Mineral Deposits:
MACHINE INSTALLATION
WARNING! To avoid a hazard due to instability of the appliance, it must be
fixed in accordance with the instrucons.
This machine should be sanized with a disinfectant and then cleaned with
water every three months. (See cleaning and draining instrucons.)
1-2. Loosen the screw of the le or right boom angle
as in the picture below.
3. Use the screw to fix the bracket on the le or right
boom angle of the water dispenser.
4. Make a hole on the floor's surface where the water
dispenser will be installed.
5. Fix the bracket on the floor by screwing ghtly.
6. Tighten the screw.
To prevent the machine from swaying or falling, we have
included an oponal bracket. Please install the bracket
accordingly.