Use and Care Manual

15
Finishing the Water Cooler Installation
Once you have flushed the filters and removed the filters and PE Tubing from
the Filter Flushing Adapter, you are ready to complete the installation process.
1. Remove the plug from the water inlet (#24)
located on the back of the unit. To do this press
on the push connect ring that is behind the
plug. Push the open end of the PE Tubing into
the water inlet (#24). Make sure the PE Tubing
is tight and secure.
2. Open the cabinet door of the unit. Twist
the filters into the filter heads in the cabinet
by rotating them clockwise. The Sediment
Filter should be on the left and the Carbon
Block Filter should be on the right.
3. Turn the Valve for the water source back on
(the on position is parallel to the PE Tubing).
Getting Started