Use and Care Manual

29
Cleaning
4. Place a large cup or bucket below the
Pump Cleaning Drain (#22) located at the
lower back of the unit.
3. Turn the valve located along the back
of the cabinet above the filters to the o
position (perpendicular to the tubing).
6. Place the probe back into the 5 gallon
water jug and slide it back into the cabinet
and close the door.
1. Open the cabinet and remove the 5 gallon water bottle.
2. Pour this cleaning solution into the 5 gallon water jug.
To remove mineral deposits that may have built up inside the water pump, mix 1.5 gallons of
water with 50 g of citric acid crystals (not included) or cleaning solution of your choice. This
is recommended to be done at a time when the water bottle is already empty.
Cleaning
5. Remove the push connect plug of the
Pump Cleaning Drain (#22) by pressing in
on the grey ring and pulling on the plug
simultaneously.