Instructions / Assembly

Leak Detection

Once the area and sensors are dry, you will need to release the water pressure from the

mechanical leak detection sensor (#25). This can be done by removing the locking clip on

the left side of the mechanical leak detection sensor (as shown in picture 4). Next you will

need to remove the tubing that leads into the left side of the mechanical leak detection

sensor (as shown in picture 5) by pressing in on the push connect ring. Keep a paper towel

handy while doing this as some water may drip from the open tubing. Push the tubing

back into place and put the locking ring back on. The beeping and blinking lights will stop,

and the machine will be ready to use as normal again.

If you still seem to have an issue after following these steps, contact our customer support

for further assistance.

locking clip

tubing

User Guide and Maintenance