Use and Care Manual

20
Dispensing Water
Cold Water
Hot Water
Cool Water
Once you have turned the cooling switch (#17) into the on (I) position it will take initially
1 hour for the water to cool. During this time the cooling indicator light (#4) around the cold
water button will blink. During this time the compressor could run continuously. This is
normal. The light will be turned o when the cooling process is complete.
Once you have turned the heating switch (#18) into the on (I) position it will take
initially 15 – 20 minutes for the water to heat up. During this time the heating
indicator light (#2) above the hot water icon will be steady. The light will be turned
o when the heating process is complete.
1. Position the bottle, glass, pitcher or cooking pot below the water spout (#10).
2. Press the cool water button (#7) to begin the flow of water. You must
continue to press the cool water button in order for the water to continue to flow. While
water is dispensing, the button will light up orange.
3. Once the desired fill level is achieved release the cool water push button (#7) to stop the
flow of water.
1. Position a bottle, glass, pitcher or cooking pot below the water spout (#10).
2. Press the cold water button (#8) to begin the flow of water. You must continue to press
the cold water button in order for the water to continue to flow. While water is dispensing,
the button will light up blue.
3. Once the desired fill level is achieved, release the cold water button (#8) to stop the
flow of water.
1. Position a bottle, glass, pitcher or cooking pot below the water spout (#10).
2. Press the child safety lock push button (#5) and press the hot water button
(#6) to begin the flow of water. You must continue to press the hot water button in
order for the water to continue to flow. While water is dispensing, the button will light
up red.
3. Once the desired fill level is achieved release the hot water push button (#6) to stop
the flow of water.
User Guide and Maintenance