Installation Guide

H: MACHINEINATALLATION
3. To Remove Mineral Deposits:
Mix 4 liters water with 200g citric acid crystals, inject into the machine and
make sure the water can flow out of the hot water tap. Switch on the hot switch
and heat it about 10 minutes. Aer 30 minutes, drain out the liquid and clean it
with water two or three mes as per the cleaning and draining instrucons.
Generally this should be done every six months.
Never disassemble this machine by yourself to avoid danger from damaged
machine.
Instrucons for installaon:
1. Use the screw to fix the bracket on the hole of the
middle boom of the water dispenser.
2. Make a hole on the floor's (or the desk's) surface
where the water dispenser will be installed.
3. Fix the bracket on the floor by screw ghtly.
4. Tighten the screw.
WARNING! To avoid a hazard due to instability of the appliance, it must be
fixed in accordance with the instrucons.
5. Never disassemble this machine by yourself to avoid danger from
damaging machine.
7
If you encounter any issues or have any concerns,
please email us at [e-mail]
or call 1800-256-0695 .
Please see our website to learn more about our products
www.avalonproducts.com
©Copyright Avalon ® 2018 and Distributed by BHRS Group LLC