Installation Guide

F: TROUBLE SHOOTING
Please check the followings before having the machine repaired.
Noisy operaon
PROBLEMS
No hot or cold water
No water running
out from taps
Leakage from bole
receptacle
1. Empty bole
2. Inlet of bole supporter blocked by
bole seal
POSSIBLE CAUSES
1. Over consumpon of hot or cold
water in short me
2. No power supply
Loose bole or loose tank seal
Not installed on leveled surface
1. Replace it with another one
2. Clean out wasted paper & bole seal,
install bole again.
ELIMINATION
1. Just wait a moment ,for hot/cold water
to be available again.
2. Connect plug to socket, turn on heang
and cooling switch
Place the machine on flat surface
Reposion bole and check tank seal
G: CLEANING
To avoid accident, cut off the power supply before following the following
instrucons.
The machine had been disinfected before leaving the factory. However you
may want to clean the dispenser prior to installing a full bole or water for the
first me.
1. Cleaning and draining instrucons:
1)Before cleaning, make sure to unplug the water dispenser.
2)Vercally insert the bole into the receptacle on top of the machine.
3)Press the dispensing buons and allow about 1 liter of water to flow into
a container.
4)Remove the water bole from the dispenser.
5)Place a large bucket beneath the drain outlet. Remove the drain cover and
plug and allow water to drain.
6)Aer draining, replace the drain plug and cover and you can use the machine.
Aenon: The dispenser heats water to a temperature of approximately
185 F/85 C. It can cause sever scalding. Please operate it carefully.
2. Sanizing
The machine should be disinfected with disinfectant separately bought from
drugstore or marketplace according to the instrucon manual or the
disinfectant and the clean it with water (see cleaning and draining instrucon).
Generally this should be done every three months.
6