Installation Guide
C: OPERATION INSTRUCTION
1. Remove any scker or label from the opening or cap of the bole.
2. Vercally insert the bole into the bole receptacle
on top of the machine. Don't plug the power cord or
turn on the heang or cooling switches unl water is
dispensed from the hot and cold water spouts.
3. Insert the plug to into an electrical outlet.
4. Dispense a drop of water from both the hot and cold
spouts to ensure the inner tanks have water in them.
5. Turn on the heang and cooling switches.
6. Indicators will light up accordingly once the machine starts to work.
7. Vercally pull out the bole with two hands when the bole is empty, then
replace it with another bole of water.
8. This appliance should be kept in temperature from 50°F-110°F.
9. This appliance is not suitable for installaon in an area where a water jet
could be used.
D:CAUTION
1. Keep this machine in a dry place and avoid direct sunlight.
Rear of the machine should be at least 25cm away from the
wall. Never put the machine on paper or foam as it will cause
an unstable surface. Never put anything flammable near this
machine.
2. To avoid damage to the machine, don't turn on the heang or
cooling switches unl some water is dispensed from the hot
and cold spouts.
3. In case hot or cold water is not needed for a long me, turn
off the switch to save power.
4